Gap adjustment: The installation staff can adjust the gap between the inside of the walking wheel and the track of the steel and the steel track of the workers by adjusting the pad. At the same time, it is necessary to ensure that the gap is 3-5mm.

Adjustment of motor spindle spindle: In the case of 1.5mm, the axis directional volume of the tapered rotor motor is a shaft, and its braking effect is good. Therefore, in order to ensure its operating effect, the following measures can be taken to adjust the motor spindle.

1. Adjustment of electric gourd motors below 5T: The installation personnel need to remove the tail cover, and then use a wrench to adjust the nut to rotate to the limit position, then rotate the clockwise counter for a week, and then install the firing screw.

2. The motor adjustment method of 10T and 16T electric gourds is the same as above. The adjustment direction of the rotation of the nut is different. The amount of momentum will be reduced. Adjustment of the fire -breaking limiter: The installer can adjust the fire -breaking limiter by adjusting the bumps on the limit rod. The specific adjustment method is: unload the screw on the collision block and put it on the bump to put it on the guide card card card. On both sides of the board, the collision will move with the stuck board. After starting, the motor will rise, and the collision block is also moved with the cardboard. The surgery of the hook pulley is rising. Then you need to press the downtime button to move about 1cm at the guide rope. Then use the screw to fix the upper limit block. The offline position adjustment is the same as the above method, but it should be noted that when the hook is at a low point, it is necessary to ensure that there are at least three circle of wire rope on the roll.