The fixing of the steel wire rope of the electric gourd is generally a plate method (the number of pressure plates is not less than 3), and the block method. Safety circle: When the hook is at a low working position, keep the safety circle of at least 2 laps on the roller (the pressure plate is pressed partially). When installing the wire rope fixed rope clip, you should pay attention to the following points: The "U" type bolt should be buckled on the tail section of the wire rope. Essence The rope clip should be selected according to the size of the nominal diameter of the wire rope. Stepping on the wire rope should be smooth, flat, and no burrs. If there are obvious slippery traces of smooth friction, you should pay attention to replacement. The fastening of the wire rope clamp: In order to ensure that the wire rope is fixed, the tail is uniform. The rope clip from the far away should be as close as possible. After a period of time, the rope should be checked on the tightening state of the nut.