Q: What inspections and preparations do you need to do before installation of electric gourds?

Answer: After the electric gourd is transported to the installation location, it is packed according to the installation of the box, and carefully checks whether there is any damage and loss of parts during the transportation; carefully read the instructions and other files of the product to understand the structure of this product; run the car, the current, the current, the current, the current, the current, and the current The introduction of the hook device is generally disintegrated with the host, and the assembly must be re -assembled when installing; the oil pollution or rust -proof paint on the stepping surface of the motor vehicle is removed; it is checked by the promotion and running a reducer according to the instructions. ; Know the installation site and prepare to install facilities.

Q: What are the precautions for electric gourd when installation?

Answer: In order to ensure that the electric gourd from the end of the two ends is not derailed or prevent the body from being damaged, the elastic buffer should be set at both ends of the track; the ground wire should be set on the rack or its connection. A metal wires with a wire or cross -section of not less than 25 square millimeters; the ground resistance of all power circuits and control circuits of the electrical device shall not be less than 1,000 ohm per voltage per volt.

Q: What are the technical requirements for electric gourd installation?

Answer: The installation of electric gourds should meet the requirements of the equipment technical document; adjust the padding ring for adjustment during installation to ensure that the gap between the inner side of the electric gourd wheel wheel and the wing edge of the steel rail should be 3-5mm.